Standard

Multimode Fiber Raman Lasers Directly Pumped by Laser Diodes. / Babin, Sergey A.; Zlobina, Ekaterina A.; Kablukov, Sergey I.

в: IEEE Journal of Selected Topics in Quantum Electronics, Том 24, № 3, 1400310, 2017.

Результаты исследований: Научные публикации в периодических изданияхстатьяРецензирование

Harvard

Babin, SA, Zlobina, EA & Kablukov, SI 2017, 'Multimode Fiber Raman Lasers Directly Pumped by Laser Diodes', IEEE Journal of Selected Topics in Quantum Electronics, Том. 24, № 3, 1400310. https://doi.org/10.1109/JSTQE.2017.2764072

APA

Babin, S. A., Zlobina, E. A., & Kablukov, S. I. (2017). Multimode Fiber Raman Lasers Directly Pumped by Laser Diodes. IEEE Journal of Selected Topics in Quantum Electronics, 24(3), [1400310]. https://doi.org/10.1109/JSTQE.2017.2764072

Vancouver

Babin SA, Zlobina EA, Kablukov SI. Multimode Fiber Raman Lasers Directly Pumped by Laser Diodes. IEEE Journal of Selected Topics in Quantum Electronics. 2017;24(3):1400310. doi: 10.1109/JSTQE.2017.2764072

Author

Babin, Sergey A. ; Zlobina, Ekaterina A. ; Kablukov, Sergey I. / Multimode Fiber Raman Lasers Directly Pumped by Laser Diodes. в: IEEE Journal of Selected Topics in Quantum Electronics. 2017 ; Том 24, № 3.

BibTeX

@article{68644fd8c15b4e118828b2716357aa8c,
title = "Multimode Fiber Raman Lasers Directly Pumped by Laser Diodes",
abstract = "Raman fiber lasers (RFLs) are usually based on single-mode fibers core-pumped by high-power rare-earth-doped fiber lasers with single transverse mode output that leads to a rather complicated design of RFLs. One of interesting possibilities to simplify the RFL design is its direct pumping by cheap and reliable high-power multimode laser diodes (LDs). It is attractive to use standard graded-index multimode passive fibers characterized by very high quality and low cost due to their wide use in telecom. In this case, one can directly couple the multimode radiation of high-power LDs with moderate brightness into the core of multimode graded-index fiber with much higher efficiency than into the core of single-mode fiber. Using commercially available multimode LDs with operating wavelengths of 915–940 nm, it is possible to obtain high-power high-beam-quality Raman lasing in wavelength range of 950–1000 nm, which is problematic for rare-earth-doped fiber lasers. Here, we review the results obtained in this direction and report on the demonstration of all-fiber LD-pumped CW Raman laser based on the graded-index fiber. A joint action of Raman clean-up effect and mode-selection properties of special fiber Bragg gratings inscribed in the central part of fiber core, results in high-efficiency conversion of multimode (M2∼26) pump at 915 nm into a high-quality output beam at 954 nm. Fibers with core diameter of 62.5, 85, and 100 µm are compared. With core enlargement, the conversion efficiency increases sufficiently (from 47% to 84%) at the expense of slight beam-quality parameter reduction (M2 = 1.3–3). The generated spectrum remains to be rather narrow (<0.4 nm) at output power >60 W .",
keywords = "Fiber laser, Raman laser, GRIN fiber, multimode, diode pumping, pump combiner, fiber Bragg gratings, Rayleigh scattering, single-mode output, HIGH-EFFICIENCY, BRAGG GRATINGS, OPTICAL-FIBER, BEAM, CLEANUP, NM, CW",
author = "Babin, {Sergey A.} and Zlobina, {Ekaterina A.} and Kablukov, {Sergey I.}",
note = "Publisher Copyright: {\textcopyright} 2017 IEEE.",
year = "2017",
doi = "10.1109/JSTQE.2017.2764072",
language = "English",
volume = "24",
journal = "IEEE Journal of Selected Topics in Quantum Electronics",
issn = "1077-260X",
publisher = "IEEE-INST ELECTRICAL ELECTRONICS ENGINEERS INC",
number = "3",

}

RIS

TY - JOUR

T1 - Multimode Fiber Raman Lasers Directly Pumped by Laser Diodes

AU - Babin, Sergey A.

AU - Zlobina, Ekaterina A.

AU - Kablukov, Sergey I.

N1 - Publisher Copyright: © 2017 IEEE.

PY - 2017

Y1 - 2017

N2 - Raman fiber lasers (RFLs) are usually based on single-mode fibers core-pumped by high-power rare-earth-doped fiber lasers with single transverse mode output that leads to a rather complicated design of RFLs. One of interesting possibilities to simplify the RFL design is its direct pumping by cheap and reliable high-power multimode laser diodes (LDs). It is attractive to use standard graded-index multimode passive fibers characterized by very high quality and low cost due to their wide use in telecom. In this case, one can directly couple the multimode radiation of high-power LDs with moderate brightness into the core of multimode graded-index fiber with much higher efficiency than into the core of single-mode fiber. Using commercially available multimode LDs with operating wavelengths of 915–940 nm, it is possible to obtain high-power high-beam-quality Raman lasing in wavelength range of 950–1000 nm, which is problematic for rare-earth-doped fiber lasers. Here, we review the results obtained in this direction and report on the demonstration of all-fiber LD-pumped CW Raman laser based on the graded-index fiber. A joint action of Raman clean-up effect and mode-selection properties of special fiber Bragg gratings inscribed in the central part of fiber core, results in high-efficiency conversion of multimode (M2∼26) pump at 915 nm into a high-quality output beam at 954 nm. Fibers with core diameter of 62.5, 85, and 100 µm are compared. With core enlargement, the conversion efficiency increases sufficiently (from 47% to 84%) at the expense of slight beam-quality parameter reduction (M2 = 1.3–3). The generated spectrum remains to be rather narrow (<0.4 nm) at output power >60 W .

AB - Raman fiber lasers (RFLs) are usually based on single-mode fibers core-pumped by high-power rare-earth-doped fiber lasers with single transverse mode output that leads to a rather complicated design of RFLs. One of interesting possibilities to simplify the RFL design is its direct pumping by cheap and reliable high-power multimode laser diodes (LDs). It is attractive to use standard graded-index multimode passive fibers characterized by very high quality and low cost due to their wide use in telecom. In this case, one can directly couple the multimode radiation of high-power LDs with moderate brightness into the core of multimode graded-index fiber with much higher efficiency than into the core of single-mode fiber. Using commercially available multimode LDs with operating wavelengths of 915–940 nm, it is possible to obtain high-power high-beam-quality Raman lasing in wavelength range of 950–1000 nm, which is problematic for rare-earth-doped fiber lasers. Here, we review the results obtained in this direction and report on the demonstration of all-fiber LD-pumped CW Raman laser based on the graded-index fiber. A joint action of Raman clean-up effect and mode-selection properties of special fiber Bragg gratings inscribed in the central part of fiber core, results in high-efficiency conversion of multimode (M2∼26) pump at 915 nm into a high-quality output beam at 954 nm. Fibers with core diameter of 62.5, 85, and 100 µm are compared. With core enlargement, the conversion efficiency increases sufficiently (from 47% to 84%) at the expense of slight beam-quality parameter reduction (M2 = 1.3–3). The generated spectrum remains to be rather narrow (<0.4 nm) at output power >60 W .

KW - Fiber laser

KW - Raman laser

KW - GRIN fiber

KW - multimode

KW - diode pumping

KW - pump combiner

KW - fiber Bragg gratings

KW - Rayleigh scattering

KW - single-mode output

KW - HIGH-EFFICIENCY

KW - BRAGG GRATINGS

KW - OPTICAL-FIBER

KW - BEAM

KW - CLEANUP

KW - NM

KW - CW

UR - http://www.scopus.com/inward/record.url?scp=85032437586&partnerID=8YFLogxK

U2 - 10.1109/JSTQE.2017.2764072

DO - 10.1109/JSTQE.2017.2764072

M3 - Article

VL - 24

JO - IEEE Journal of Selected Topics in Quantum Electronics

JF - IEEE Journal of Selected Topics in Quantum Electronics

SN - 1077-260X

IS - 3

M1 - 1400310

ER -

ID: 18647615