Standard

Gap Cavitation in the End Clearance of a Guide Vane of a Hydroturbine : Numerical and Experimental Investigation. / Sentyabov, A. V.; Timoshevskiy, M. V.; Pervunin, K. S.

In: Journal of Engineering Thermophysics, Vol. 28, No. 1, 01.01.2019, p. 67-83.

Research output: Contribution to journalArticlepeer-review

Harvard

Sentyabov, AV, Timoshevskiy, MV & Pervunin, KS 2019, 'Gap Cavitation in the End Clearance of a Guide Vane of a Hydroturbine: Numerical and Experimental Investigation', Journal of Engineering Thermophysics, vol. 28, no. 1, pp. 67-83. https://doi.org/10.1134/S1810232819010065

APA

Sentyabov, A. V., Timoshevskiy, M. V., & Pervunin, K. S. (2019). Gap Cavitation in the End Clearance of a Guide Vane of a Hydroturbine: Numerical and Experimental Investigation. Journal of Engineering Thermophysics, 28(1), 67-83. https://doi.org/10.1134/S1810232819010065

Vancouver

Sentyabov AV, Timoshevskiy MV, Pervunin KS. Gap Cavitation in the End Clearance of a Guide Vane of a Hydroturbine: Numerical and Experimental Investigation. Journal of Engineering Thermophysics. 2019 Jan 1;28(1):67-83. doi: 10.1134/S1810232819010065

Author

Sentyabov, A. V. ; Timoshevskiy, M. V. ; Pervunin, K. S. / Gap Cavitation in the End Clearance of a Guide Vane of a Hydroturbine : Numerical and Experimental Investigation. In: Journal of Engineering Thermophysics. 2019 ; Vol. 28, No. 1. pp. 67-83.

BibTeX

@article{655927514fdb4c01a60da09900f5db59,
title = "Gap Cavitation in the End Clearance of a Guide Vane of a Hydroturbine: Numerical and Experimental Investigation",
abstract = "The article presents results of numerical and experimental investigation of cavitation flow around two subscale models of guide vanes of hydroturbines, one of which has a simplified geometry, while the other has an approximately real geometry. The emphasis was on studying the fluid flow through the gap between the end surface of the hydrofoil and the channel wall, and also on the onset and development of gap cavitation. In the study we used high-speed imaging to analyze the spatial structure and dynamics of cavities. The two-dimensional flow velocity distributions above the hydrofoil surface were measured by the PIV method. In the numerical simulation of cavitation flows around the vanes we used computational fluid dynamics methods based on the solution of Reynolds equations for turbulent flows by means of the finite volume method on a three-dimensional grid of hexahedral cells. The vapor phase was accounted for by solving the equation of transport of vapor fraction. Turbulence was described by the DES method based on a two-parameter model, k-ω SST. As a result, we compared the calculated profiles of flow velocity in the boundary layer on the low-pressure side of the vane with the measurement results; they were in good agreement. In the experiment and in the numerical simulation cavitating vortex structures were observed along with gap cavitation as a vapor film while the fluid was flowing through a narrow gap. At a small angle of attack the vapor film in the gap forms in the vicinity of the trailing edge of the hydrofoil, and immediately behind its leading edge at large angles of attack. In unsteady flow regimes the gap cavitation dynamics substantially depends of the phase of development of the main cavity on the low-pressure side of the vane decompression.",
keywords = "TIP-LEAKAGE VORTEX, FLOW, COMPUTATIONS, RANS",
author = "Sentyabov, {A. V.} and Timoshevskiy, {M. V.} and Pervunin, {K. S.}",
year = "2019",
month = jan,
day = "1",
doi = "10.1134/S1810232819010065",
language = "English",
volume = "28",
pages = "67--83",
journal = "Journal of Engineering Thermophysics",
issn = "1810-2328",
publisher = "Maik Nauka-Interperiodica Publishing",
number = "1",

}

RIS

TY - JOUR

T1 - Gap Cavitation in the End Clearance of a Guide Vane of a Hydroturbine

T2 - Numerical and Experimental Investigation

AU - Sentyabov, A. V.

AU - Timoshevskiy, M. V.

AU - Pervunin, K. S.

PY - 2019/1/1

Y1 - 2019/1/1

N2 - The article presents results of numerical and experimental investigation of cavitation flow around two subscale models of guide vanes of hydroturbines, one of which has a simplified geometry, while the other has an approximately real geometry. The emphasis was on studying the fluid flow through the gap between the end surface of the hydrofoil and the channel wall, and also on the onset and development of gap cavitation. In the study we used high-speed imaging to analyze the spatial structure and dynamics of cavities. The two-dimensional flow velocity distributions above the hydrofoil surface were measured by the PIV method. In the numerical simulation of cavitation flows around the vanes we used computational fluid dynamics methods based on the solution of Reynolds equations for turbulent flows by means of the finite volume method on a three-dimensional grid of hexahedral cells. The vapor phase was accounted for by solving the equation of transport of vapor fraction. Turbulence was described by the DES method based on a two-parameter model, k-ω SST. As a result, we compared the calculated profiles of flow velocity in the boundary layer on the low-pressure side of the vane with the measurement results; they were in good agreement. In the experiment and in the numerical simulation cavitating vortex structures were observed along with gap cavitation as a vapor film while the fluid was flowing through a narrow gap. At a small angle of attack the vapor film in the gap forms in the vicinity of the trailing edge of the hydrofoil, and immediately behind its leading edge at large angles of attack. In unsteady flow regimes the gap cavitation dynamics substantially depends of the phase of development of the main cavity on the low-pressure side of the vane decompression.

AB - The article presents results of numerical and experimental investigation of cavitation flow around two subscale models of guide vanes of hydroturbines, one of which has a simplified geometry, while the other has an approximately real geometry. The emphasis was on studying the fluid flow through the gap between the end surface of the hydrofoil and the channel wall, and also on the onset and development of gap cavitation. In the study we used high-speed imaging to analyze the spatial structure and dynamics of cavities. The two-dimensional flow velocity distributions above the hydrofoil surface were measured by the PIV method. In the numerical simulation of cavitation flows around the vanes we used computational fluid dynamics methods based on the solution of Reynolds equations for turbulent flows by means of the finite volume method on a three-dimensional grid of hexahedral cells. The vapor phase was accounted for by solving the equation of transport of vapor fraction. Turbulence was described by the DES method based on a two-parameter model, k-ω SST. As a result, we compared the calculated profiles of flow velocity in the boundary layer on the low-pressure side of the vane with the measurement results; they were in good agreement. In the experiment and in the numerical simulation cavitating vortex structures were observed along with gap cavitation as a vapor film while the fluid was flowing through a narrow gap. At a small angle of attack the vapor film in the gap forms in the vicinity of the trailing edge of the hydrofoil, and immediately behind its leading edge at large angles of attack. In unsteady flow regimes the gap cavitation dynamics substantially depends of the phase of development of the main cavity on the low-pressure side of the vane decompression.

KW - TIP-LEAKAGE VORTEX

KW - FLOW

KW - COMPUTATIONS

KW - RANS

UR - http://www.scopus.com/inward/record.url?scp=85064762640&partnerID=8YFLogxK

U2 - 10.1134/S1810232819010065

DO - 10.1134/S1810232819010065

M3 - Article

AN - SCOPUS:85064762640

VL - 28

SP - 67

EP - 83

JO - Journal of Engineering Thermophysics

JF - Journal of Engineering Thermophysics

SN - 1810-2328

IS - 1

ER -

ID: 19650000