Experimental investigation of freestream disturbances across an oblique shock wave via modal analysis with a wedge hot-film

Standard

Experimental investigation of freestream disturbances across an oblique shock wave via modal analysis with a wedge hot-film. / Krause, M.; Gaisbauer, U.; Kraemer, E. et al.

In: Thermophysics and Aeromechanics, Vol. 26, No. 6, 01.11.2019, p. 789-802.

Research output: Contribution to journal › Article › peer-review

Author

Krause, M. ; Gaisbauer, U. ; Kraemer, E. et al. / Experimental investigation of freestream disturbances across an oblique shock wave via modal analysis with a wedge hot-film. In: Thermophysics and Aeromechanics. 2019 ; Vol. 26, No. 6. pp. 789-802.

BibTeX

@article{a1ac9ca5c77043e88977ca13cb085759,

title = "Experimental investigation of freestream disturbances across an oblique shock wave via modal analysis with a wedge hot-film",

abstract = "An experimental fluctuation analysis is usually conducted via thermal anemometry with hot-wires. However, in the vicinity of oscillating shock waves, this kind of sensor can be destroyed due to strong mechanical loads. On the basis of a sufficient modelling, a wedge-shaped hot-film can be suitable for a quantitative fluctuation analysis across a shock wave. Within this study, the modal analysis according to Kov{\'a}sznay and Morkovin was adapted from hot-wires to the used wedge hot-film. Additionally, 3-dimensional fluctuation diagrams were derived for the separate as well as for mixed modes. The freestream fluctuations were detected across an oblique shock wave with a wedge hot-film in a constant-temperature mode. The shock was caused by a ramp with a 10° ramp angle placed in a flow with a Mach number of M = 2.5 and a unit Reynolds number of Reunit = 4.96·106·m−1. The recorded perturbations were decomposed according to the modal analysis and found to be dominated by the acoustic mode. The fluctuations{\textquoteright} amplification across the shock wave and the subsequent decay could clearly be detected. They are in good agreement with the literature.",

keywords = "fluctuation diagram, modal analysis, oblique shock, wedge hot-film, ANEMOMETER, HEAT-TRANSFER",

author = "M. Krause and U. Gaisbauer and E. Kraemer and Kosinov, {A. D.}",

year = "2019",

month = nov,

day = "1",

doi = "10.1134/S0869864319060015",

language = "English",

volume = "26",

pages = "789--802",

journal = "Thermophysics and Aeromechanics",

issn = "0869-8643",

publisher = "PLEIADES PUBLISHING INC",

number = "6",

}

RIS

TY - JOUR

T1 - Experimental investigation of freestream disturbances across an oblique shock wave via modal analysis with a wedge hot-film

AU - Krause, M.

AU - Gaisbauer, U.

AU - Kraemer, E.

AU - Kosinov, A. D.

PY - 2019/11/1

Y1 - 2019/11/1

N2 - An experimental fluctuation analysis is usually conducted via thermal anemometry with hot-wires. However, in the vicinity of oscillating shock waves, this kind of sensor can be destroyed due to strong mechanical loads. On the basis of a sufficient modelling, a wedge-shaped hot-film can be suitable for a quantitative fluctuation analysis across a shock wave. Within this study, the modal analysis according to Kovásznay and Morkovin was adapted from hot-wires to the used wedge hot-film. Additionally, 3-dimensional fluctuation diagrams were derived for the separate as well as for mixed modes. The freestream fluctuations were detected across an oblique shock wave with a wedge hot-film in a constant-temperature mode. The shock was caused by a ramp with a 10° ramp angle placed in a flow with a Mach number of M = 2.5 and a unit Reynolds number of Reunit = 4.96·106·m−1. The recorded perturbations were decomposed according to the modal analysis and found to be dominated by the acoustic mode. The fluctuations’ amplification across the shock wave and the subsequent decay could clearly be detected. They are in good agreement with the literature.

AB - An experimental fluctuation analysis is usually conducted via thermal anemometry with hot-wires. However, in the vicinity of oscillating shock waves, this kind of sensor can be destroyed due to strong mechanical loads. On the basis of a sufficient modelling, a wedge-shaped hot-film can be suitable for a quantitative fluctuation analysis across a shock wave. Within this study, the modal analysis according to Kovásznay and Morkovin was adapted from hot-wires to the used wedge hot-film. Additionally, 3-dimensional fluctuation diagrams were derived for the separate as well as for mixed modes. The freestream fluctuations were detected across an oblique shock wave with a wedge hot-film in a constant-temperature mode. The shock was caused by a ramp with a 10° ramp angle placed in a flow with a Mach number of M = 2.5 and a unit Reynolds number of Reunit = 4.96·106·m−1. The recorded perturbations were decomposed according to the modal analysis and found to be dominated by the acoustic mode. The fluctuations’ amplification across the shock wave and the subsequent decay could clearly be detected. They are in good agreement with the literature.

KW - fluctuation diagram

KW - modal analysis

KW - oblique shock

KW - wedge hot-film

KW - ANEMOMETER

KW - HEAT-TRANSFER

UR - http://www.scopus.com/inward/record.url?scp=85080104972&partnerID=8YFLogxK

U2 - 10.1134/S0869864319060015

DO - 10.1134/S0869864319060015

M3 - Article

AN - SCOPUS:85080104972

VL - 26

SP - 789

EP - 802

JO - Thermophysics and Aeromechanics

JF - Thermophysics and Aeromechanics

SN - 0869-8643

IS - 6

ER -

ID: 25837323